marx1
@marx1
Reputable Member
Joined: Aug 4, 2008
Topics: 40 / Replies: 169
Topic
Reply
RE: What Happened?

covewi wrote:Thank you - I just got home and see another area of condensation on the other side (the earlier condensation is gone). Looks like I shoul...

9 years ago
Reply
RE: SanDevices version 5 firmware information thread

deonb wrote:Is there any way to reset the firmware to be all 0's? Sometimes I get the controller to go into a mode that displays like this:And then n...

9 years ago
Reply
RE: What Happened?

Try adding a desiccant pack to the case. Heat + cold = Condensation, and water + electronics = corrosion & shorts. If you can vent it with something...

9 years ago
Reply
RE: SanDevices version 5 firmware information thread

greenie95125 wrote:Yup, sounds like a timing issue. I had similar problems when I upgraded to 5.x All my port timings are at 400 now, and everything w...

9 years ago
Reply
RE: Wanted: IC for E682 (SN74HCT541N)

That's much different from my issue. I ended up doing a bunch of testing and reverted back to v4.0.81 of the Sandevices firmware and it's fixed. I hav...

9 years ago
Reply
RE: Renard SS16 Multiple channels blink during single channel brightness fade Vixen

ctmal wrote:We had a similar issue with our mega tree. We resolved it by installing power conditioners(I forget the actual name of them at this point...

9 years ago
Forum
Reply
RE: SanDevices version 5 firmware information thread

So I just setup my show, and I'm running into issues with my E682. I have two DMX devices off of it - a Dumb "DMX" controller from Ray Wu ant works gr...

9 years ago
Reply
RE: Renard SS16 Multiple channels blink during single channel brightness fade Vixen

Is your renard connected directly to the PC or via a e1.31 device, like the San Devices E682? I have similar problems during fade on my Renard24 when ...

9 years ago
Forum
Reply
RE: Wanted: IC for E682 (SN74HCT541N)

What "issue" are you trying to fix? I'm fighting flickering when using DMX off my E682 on a Renard24. I have a dumb dmx controller and it works fine, ...

9 years ago
Reply
RE: FPP Networking - Cant get outside my network

Verify your gateway for the wireless is still set. I've had weird issues happen. Try and ssh in, and do a ip route, see if you have two gateways liste...

9 years ago
Topic
Replies: 0
Views: 4
Topic
Replies: 0
Views: 6
Reply
RE: My turn to do a minor rant....

There are two fry's in the Sacramento area, One in Natomas and the other in Roseville. They have parts by the computer component section. For the Nato...

9 years ago
Forum
Reply
RE: Plastic net for pixels with large spacing

StickyWicket wrote:Keep in mind just because they space the holes a certain distance apart in the net doesn't mean you have to use all the holes. Hol...

10 years ago
Page 3 / 14