angus40 wrote:This is the section you need to look at in your code and do the opposite for your inverted needs if (MODE == NOT_INVERTED) { for (i=0;...
angus40 wrote:Post #223 gives you a tip . Being that you want inverted for the first 24 channels , you can set the #define to inverted rather than not...
angus40 wrote:Post #223 gives you a tip . Being that you want inverted for the first 24 channels , you can set the #define to inverted rather than not...
My coding skills are still pretty abysmal, and the code I attempted to write didn't compile, and it just led to a futile scurry of errors and ill writ...
I'm not sure if this is the right place to ask, but is it possible to modify the code so that, for example, I could define channels 1-24 as INVERTED w...
RGB_Mixer wrote:2 Pin connectors ... 3 Pin connectors ... Crimping Tool, full kit. I recommend the kit -- it will be useful in learning how to ...
RGB_Mixer wrote: What you CAN do using the round 3 pin connectors is to create a 2 pin port to inject with. Take a male and female 3 pin round con...
jchuchla wrote:The need to inject is often caused by the small conductor diameter in a pixel string, combined with the additive resistance of all thos...
The link no longer works, any chance someone had some of the simple relay on/off sequences mentioned here? Thanks!
Maybe this thread will help. The sketch was for WiFi via the ESP-01 but perhaps it will help get you where you need to be. doityourselfchristmas.com/...
I have a mega in case the uno doesn't work out so no big deal there. I did manage to get it i compile and upload to the uno but have run into a wall g...
Re: Success Modifying VictorPV and ZParticle Sketches to Accept Renard Protocol Oh yeah, I'll add that I added the Renard-master library authored by ...
Re: Success Modifying VictorPV and ZParticle Sketches to Accept Renard Protocol Thank god someone replied so promptly! Ok. So with the ESP8266 (or E...
Since the ESPixelstick uses the ESP8266 module, would I be able to Kev's code, posted at beginning of this thread, for an Arduino Uno (or Mega) if I a...
