kmalsom
@kmalsom
Reputable Member
Joined: Nov 29, 2012
Topics: 20 / Replies: 330
Reply
RE: Newbie with Nuttin' Collected Would Appreciate Input on 5v/12v vs 110v

If you aren't going to do a lot of lights, you could use the incandescent lights that you have. They probably draw about .4 amps per string of 100 (l...

12 years ago
Reply
RE: Trouble with downloading firmware

The CAT5 is for the serial connection. See: There are many USB to RS-485 adapters on ebay or amazon. I don't remember if the Renard-Plus has the cap...

12 years ago
Forum
Reply
RE: Christmas Light Fight starts tonight on ABC...

Your music was much better than what they showed on the show. Great job and thanks for the tutorials, they've been inspirational.

12 years ago
Forum
Reply
RE: Trouble with downloading firmware

you need a PIC programmer, the connection is for RS485 and is not an ethernet cord. It is probably already programmed if you got it from Radiant Holi...

12 years ago
Forum
Reply
RE: Channels staying on.

I also had an issue where the Hot and Neutral were reversed on the power coming in. Switched the hot and neutral to be correct and the problem went a...

12 years ago
Forum
Reply
RE: Micro DC Renard?

frederic wrote:I downloaded both Eagle and KiCad, futzed with them a bit, and decided to do this in Visio just because I could bang it out faster that...

12 years ago
Forum
Reply
RE: Komby Pixel Optimization

I don't think the RFShow protocol limits to 512 channels does it? I thought the limit was 4584 () and that it depended on the speed that you were tra...

12 years ago
Forum
Reply
RE: Turn off feed to outside lights while working

Don't have the application in front of me, so this may not be exactly right: From the main screen click "setup display". Then select your controller...

12 years ago
Reply
RE: USB to RS485 adapter

Was using renard ss controllers and didn't worry about the ground since it was working.

12 years ago
Forum
Reply
RE: USB to RS485 adapter

They do not have a ground connection, but so far have not noticed any problems. I have to say though, I used it last year, but this year I am using a...

12 years ago
Forum
Reply
RE: PCB in bulk - best manufacturer

I've done elecrow and have had good luck.

12 years ago
Reply
RE: USB to RS485 adapter

I have one of those. It works OK once you get it set up. I had to go hunt for the drivers.

12 years ago
Forum
Reply
RE: The Colorado Connection - welcome!

I run Vixen 3 and am running GECE pixels off of it. I'd be willing to show you, but My show is not all set up at the moment. Because of some issues,...

12 years ago
Reply
RE: delays delays delays

I feel for you. My display still isn't up and probably won't completely be. I was welding some props and after getting them together determined that...

12 years ago
Forum
Reply
RE: Happy Birthday kmalsom

Thank you for the birthday wishes! 🙂

12 years ago
Forum
Page 5 / 24