rewired the dongle but I still have issues. I’ll be just plugging in the lights so they are on this year.
Aurbo99 wrote: Check your Windows power saving options. A few years back my Com ports were put in sleep mode after 15 minutes to conserve power, I ch...
ctmal wrote: Can you give more details on this? Am I understanding that when you changed the baud rate to 115200 you got some of your lights to work?...
I should note I don’t own a meater to test anything. I have never used one either.
BillW wrote: Just came across your post. If your LED power light is not lit most likely you have no power. Have you used the troubleshooting guide in ...
memphislights2 wrote: Looks like you have this Amazon USB-RS485 adapter. Comparing the last image to the Wiki wiring, looks like wires are in the corr...
I don’t get out and about. So I’m not even sure where these big displays are sadly. Custom cable meaning a cat cable I cut snd spliced the wires int...
ctmal wrote: Any results from my suggestions? I did increase baud rate today. I was able to seee one of my items in my yard flag like it wanted to...
MartinMueller2003 wrote: Do any of the controller LEDs work? The RX and FE LEDs are very helpful in diagnosing VOMM errors. No, none of them work. T...
i don't have another controller either
memphislights2 wrote: Do these LED's light at all when you are passing it data? I have more experience with xLights, but does Vixen have a test func...
memphislights2 wrote: that has never done anything
memphislights2 wrote: ctmal, it doesn't look like the power led is lit, although I had the issue because I didn't solder a leg. the power LED has ne...
i did look at the fuse. they look good. they dont look blow. when i plug the lights in. they flash for about .5 seconds
