jrock64
jrock64
@jrock64
Noble Member
Joined: May 31, 2007
Topics: 112 / Replies: 987
Reply
RE: Replace LED's in Gemmy Kaleidoscope Light

I have 9 of those I picked up on sale last year. Plan was to mount the motor and crystal on the 4inch telco boxes. Replace the LEDs with 4 rgb stars a...

9 years ago
Forum
Reply
RE: WTB 40mm modules

I only used 3 LED modules, and they were plenty bright. See this thread. Joel

10 years ago
Reply
RE: Outdoor rgb soffit thin recessed lights

I attached 1 Meter RGB dumb strips to roof drip edge or Steel style D drip edge. The LEDs are zip tied to the wide part. On my house I could just for...

10 years ago
Forum
Reply
RE: Progress on the P6s for this years upgrade

Postmordem on the jacket project. The matrix was a 64 x 64 matrix composed of 8 P6 panels Overall a huge success. Everyone that saw it wanted my jack...

10 years ago
Reply
RE: Who bleaches their beard to get in the spirit.

And the final results. Joel Merry Christmas all

10 years ago
Forum
Topic
Forum
Replies: 6
Views: 2505
Reply
RE: Points of Light

OK I understand the concept, but the actual values are eluding me. The actual values for the motor are 120v 2w so less than .05 amps. 5.34k ohms r...

10 years ago
Forum
Reply
RE: Points of Light

Wolfie. Thee separate RGB LEDs individually controlled with dimming. Plus 1 white So 10 channels just for the LEDs. Are you suggesting a capacitor ac...

10 years ago
Forum
Reply
RE: Points of Light

OK latest update. While the RGB LEDs had six terminals, they joined the grounds, so they need to be driven from the source side. Jumping a wire from ...

10 years ago
Forum
Reply
RE: Progress on the P6s for this years upgrade

I removed the plastic backer from the board and carefully ran them thru a table saw. The fiberglass was not touched. joel

10 years ago
Reply
RE: Progress on the P6s for this years upgrade

Getting closer Now you see it Now you dont The 24" wires I had were still too short, so thee BBB had to move also. So much to do, so little time.

10 years ago
Reply
RE: Points of Light

Thanks for the try any way. Looks like I am back to plan A. Crude and dirty, but workable.

10 years ago
Forum
Reply
RE: Points of Light

I could be wrong, but this is the best my multimeter can come up with. The 8 pin IC -- . ++ -- . -- -- . Pin 15 -- . Pin 13The large IC ...

10 years ago
Forum
Reply
RE: Points of Light

In this case there is really nothing interesting on the back A 470 cap to smooth out the power A MOC3023 and BT134 to control the motor and the radio....

10 years ago
Forum
Reply
RE: Points of Light

More specs It helps if you read the instructions. The RGB is a 3w LED and the white is a 1w So only 200ma per channel, well within the range of a ULN...

10 years ago
Forum
Page 2 / 74