Easy enough to switch to 0x91. Thanks for the link. Will do some digging to see what it takes to get a proper vendor ID. Considered using RDM but...
The current board (have about 30) needs another rev to clear out a couple of airwires. I'll clean it up & post a parts list when I can. May also rep...
Just took delivery of a big brick of DIY through-hole pixel boards. Schematic & link to online store is here:
Just took delivery of a big brick of DIY pixel boards. Schematic posted at the link below. These can be 'field programmed' using the jumper trick me...
EDIT: Added some photos to the link above which detail the wiring harnesses and ribbon cable DMX drivers.
srm wrote:Hi Jec, and maybe remove the servo pins & replace with dmx programming, and may be a DMX termination header as well ? or keep servo 1 + 2 r...
I'm ordering a few hundred new boards of the DIY 5 channel design in about a week. It would cost me a few dollars extra to have new board files run, ...
Sorry for not being more clear. I'll order a big stack of the bare through-hole boards as well as a batch of fully assembled boards.
Just a quick update - will be placing this order in about 10 days.
UPDATE 2/2/09 - Pixel String has been sold. Thanks!
rca wrote:JEC, So the through hole board gets it power over the Cat5, is that correct? I'm assuming we could use the Power Injector board on your si...
DennyMo wrote:Just to clarify, these are the 3-color pixels, right? Didn't you also do some 5-color pixels? Thanks. Yes, these are the 3 color pix...
