freudhawk wrote:I like Akentut's snowflake but I need a snowflake that will allow the pixels to lay flat. I was going to use this one from Lithgowligt...
Spacing is a personal preference imo, however at 20' the 3" may be a little too wide apart. An alternative would be a 1/2 or 3/4 round tree? If my cal...
I've been in Private Medical Aid administration for 22 years with the same company - started on the bottom rung in Call Center, then onto Corporate Cl...
I used PLA for some first test prints on my I3 and found it too hit and miss changed to ABS and haven't looked back... no smell, prints are spot on ac...
Very nice and clean! By far the best I've seen so far 😉
I took the plunge in December and ordered a Prusa i3 kit to start with; it included a couple of add-ons like all-metal hot end, heated bed, auto-bed l...
Hi DanJ, I cast my own concrete stands for each of my North Poles - makes them sturdy during high wind and they're portable when needed; had some roug...
That's amazing Wolfie!
LOL! 😉 The contour paste has held up nicely to the thunderstorms experienced the past 2 days; no signs of melting this time! I'd certainly recomm...
Many thanks relic1882 - appreciated! 🙂
Never used the video feature before on my phone before - here's a quick couple of basic clips... From the entrance gate walking in: From the inside...
Some additional pictures!
Just an update on the "snow recipe" mentioned a few posts back - it did not stand up at all to the first rain showers, even though it was sealed with ...
@ OP - thanks for this info - I was looking for something locally, but could not find anything suitable, but these are very do-able with the local har...
