You might want to investigate to see why you blew a fuse - they are there to protect the electronics from too much current, possibly you are trying to...
that's good news! Another great story for the amazingly robust SS24.
that's a good question - I assume it depends on how you have configured things in your sequencer. Since FPP, maybe you are creating FSEQ in xlights? ...
For what it’s worth I had a ss24 waterlogged last year. I ended up drying it out with a blow dryer - first time or two I applied power all channels c...
When I started I had never picked up a soldering iron... I also investigated DIY vs plug and play and quickly realized I would never get close to what...
I haven’t actually used it, but small and relatively cheap so should fit the bill. Sent from my iPad using Tapatalk
if you have some non-pixel elements, you will probably need to double click on the element, then it's sub element until you get specifically to the no...
I would suspect this has something to do with your controller configuration - 50 pixels exactly sounds like you may have a setting on your controller....
Thanks dlovely. I'll look around a bit, I'm not sure I want to add the Ren48LSD.
My vote is more based on what I probably should expect from vendors - reality is that when I've run into pixel issues I've just gone and spliced in fr...
I like the Snapple bottle - also like the medicine bottle ideas. Why not make use of the things lying around if they work and can save a few bucks. ...
Sounds like a lot of failures, I’ve either been really lucky or your loss rate seems high. I have 6 Ren24ss for 8 years now have never lost a triac o...
I had a problem with one of my e682s couple years ago, it was not repeatable and drove me nuts for a while. It would run fine then just stop and ther...
