Ruppro wrote:download Angry IP Scanner and copy it to your show PC (via usb drive) and run it, that will tell you the IP addresses of each device on t...
TazChaLet wrote:you said you put a static ip on computer of 192.168.1.212 but you also say the controller is on that ip you should put the computer on...
Tomorrow, I'll also just simply try pinging 192.168.1.206, the default address of an E6804. That would explain my problem, although would not explain...
I opened CMD, and did a IPCONFIG /ALL, which confirmed my subnet is what I think it is: 192.168.1.xxx
I'm reading the manual, which says to use the override code "1" to determine IP address of the controller when it is not known. I know the address, 1...
Ruppro wrote:Is the e6804 set to DHCP or Static IP? Is your PC's ethernet port configured w/ an IP address in the same subnet as the e6804? I assign...
TazChaLet wrote:when you had it inside was it connected too Ethernet switch? could be your port is not set too be static and somehow switched its addr...
Thanks for arranging this, mrGrumpy. See you there.
Ooops, that question about what laptop was not for me, as I use a desktop.
Kerry Harrison wrote:That makes a lot of sense to me. What version of windows are you running on your laptop? Thanks for your advice, I really apprec...
algerdes wrote:You are going to hear this from many here. Program your show with a good laptop/desktop. Play your show with Falcon Pi Player softwar...
The replies to using the mulitmeter to for the key check of continuity of the pigtails are clear and correct. One caveat: You will not be able to ch...
I have the exact set up shown in the second of two graphics that TazChatLet provided. I happen to have 4 AlphaPix controllers, so I have four connecti...
