Don6699
Don6699
@don6699
Estimable Member
Joined: Feb 6, 2014
Topics: 5 / Replies: 180
Reply
RE: RenardESP Information Thread

madsci1016 wrote:I'm at a loss here because I didn't get a chance to inspect the FTDI boards that were offered as programmers, but a lot of the issues...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:What about 115200? That's the default debug baud rate, but it it's in Renard mode it may be overriding that speed with what ever is s...

11 years ago
Forum
Reply
RE: What gauge wire does everyone use in different scenarios & typical wire run length?

Re: What gauge wire does everyone use in different scenarios & typical wire run lengt slugg wrote:Continuing with my theme of noob questions, I'd lik...

11 years ago
Reply
RE: RenardESP Information Thread

madsci1016 wrote:Try 115200 for the baud rate in the serial terminal. Also try 57600 Sent from my SM-T700 using Tapatalk Just in case you missed the...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:If you use a serial terminal (like the one built into Arduino) and leave it open when you connect the programmer to the board, you wi...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

Don6699 wrote:So check the output voltage of the base PCB and try another ESP? Back to square one, checked the setup and matched the headers on both t...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

It came up in Google store as Wifi Analyzer on my Samsung.

11 years ago
Forum
Reply
RE: RenardESP Information Thread

michaelc wrote:I've had similar responses from some esp chips when I was programming the espixel sticks. It was usually after I screwed up and applied...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

Unless I'am overlooking something, need to comferm my setup of the Arduino programmer, was able to up load the flash test, but the ESP loads all most ...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

r.weissbach wrote:So that's what the cable should look like when completely finished? Or is that before the tension piece is applied? Sent from my i...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

One mod that I did that helped was to move the right angle pins on the programmer to the back and change out the header on the PCB to a female, I also...

11 years ago
Forum
Reply
RE: GFCI trip - can this be anything other than a faulty power supply?

Haven't read every line but could there be a swap of hot and Neu in one of the new power supplys and the other question, how close to full load are yo...

11 years ago
Reply
RE: GFCI trip - can this be anything other than a faulty power supply?

mrGrumpy wrote:I'm not sure I get your point here, and if you are advocating that deonb doesn't have a serious issue, you need to get a better underin...

11 years ago
Reply
RE: GFCI trip - can this be anything other than a faulty power supply?

The GFCI senses any current between the hot and gnd, the hot and neu and neu to gnd. A little info from the in-tra-net: The trip threshold of a Clas...

11 years ago
Reply
RE: Renard dongle question

So what the heck is everybody using for a RS485 dongle for this hobby, I've bought two to no avail and about to give up on this and send back the part...

11 years ago
Page 3 / 13