Activity
 
Notifications
Clear all
Don6699
Don6699
@don6699
Estimable Member
Joined: Feb 6, 2014
Topics: 5 / Replies: 180
Reply
RE: RenardESP Information Thread

m1anh wrote:Don6699, I could not see the full length of your ribbon in the picture, to see where the wires are going. Is it now working? I've had it...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:So we agree? There is no issues with the design or the instructions. Doesn't explain why your cable doesn't work. Post a picture of...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

m1anh wrote:I spent many years redrawing Engineering drawings for production personnel. Ribbon Cables were a huge PITA. Mostly because engineer used t...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:By the looks of this picture, are you attaching this adapter to U4? It does not connect to U4, it connects to U5 The foot-print for...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:Your drawings are correct, Look here: Your pin 5 on the Renard connector goes to pin 8 by your numbering system, but that is pin 7...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:Your drawings are correct, Look here: Your pin 5 on the Renard connector goes to pin 8 by your numbering system, but that is pin 7...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

Are they from this build? I connected the flat cable up three ways and can't get the 5 and 7 pins to line up to power the pcb from the SS16 I have and...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

r.weissbach wrote:Ruh Roh Sent from my iPhone using Tapatalk So grabbing the connectors and ring and looking at them here's some sketches to start...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

r.weissbach wrote:Ruh Roh Sent from my iPhone using Tapatalk In there D-fence so far with some reading it could turn out that there's two foot pri...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

Don6699 wrote:Just used my VOM from the 5+ test point on my SS board to pin 5 as a back up test and pin 5 test as gnd on the SS board, so yes Just r...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

r.weissbach wrote:So pin 7 on the renesp should connect with pin 5 on the renard?? Sent from my iPhone using Tapatalk Just used my VOM from the 5+...

11 years ago
Forum
Reply
Reply
RE: RenardESP Information Thread

Don6699 wrote:Yes my flat cable is screwed up and have parts on order, but I did get the ESP powered off the SS board and it is transmitting now, on ...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

madsci1016 wrote:Also Don have you tried powering it from a Renard as opposed to using the programmer? Yes my flat cable is screwed up and have part...

11 years ago
Forum
Reply
RE: RenardESP Information Thread

A follow up on the ribbon set up, so far I'm messed up also after three tries, here’s some reference pic’s: I still think making up the 8 pin connecto...

11 years ago
Forum
Page 2 / 13
Share: