And someone was using an XBox Kinect to control dimming on an AC controller via DMX/E1.31.
Yeah, everyone is going to have a pianist sitting in front of their house when it's below freezing! it's a great demonstration of the potential of lig...
Yes, i've bought from all the vendors. He as always stood behind his products. I've had more problems with other vendors, Diyledexpress for example. I...
Check your wires at the Controller. I had a loose Data wire that caused similar issues.
Here's a link to the 3D printed skulls. They aren't cheap!!
Keith R wrote: You have to put hot glue, silicone or a backer on the LED board to keep them from shorting out on the body This portion of your post i...
The reason I dropped out of this buy was that there really didn't seem to be a reasonable solution for the Enclosure, Heat dissipation, and Power Supp...
Tried to send a PM but your mailbox is full. Can you please remove me from the list for these boards. Thanks Dan
Sandevices did/does have an Wiznet Upgrade it is called the UPG1 but I believe its was for the E680/E681. It's showing as still available on the site
IMHO Price Point is okay. Black would be my preferred color, it would disappear in the dark or with lights on. But green would be better for hiding i...
Are they deep enough to allow mounting of power supplies in sideways orientation?
pmiller wrote:So from what I understand the fan, if used, pulls air from inside. Not sure how that's going good to work if the fan is pulling the air ...
DanDan wrote:I read one of the comments and it states it was not done live. The drone video was filmed earlier in the week because the FAA had Tempo...
I zip-tie mine to 1/2 inch PVC. I believe that was the intent of the original design to make them easy to attach to PVC/EMT.
