After putting the lightbulb behind the panels I ran for 3 nights with no problems. I was so hoping the #SHW would do the trick so I wouldn't have to ...
I built a portable sub panel that I can roll out for the display, then put away afterwards. I have a 50A 220V RV plug on the back of the house that i...
I added some sides to the box that was reflecting the heat from the 60W lightbulb back on the panels, and as of tonight it has run 2.5 nights with no ...
lboucher wrote: Vixen 2.5.0.9 is freaking rock solid Just to clarify, do you mean 2.5.0.8? I don't recall seeing 2.5.0.9, if there's a 0.9, i'll ha...
holtm wrote:Are you sure it is the Tricks-C that stops? Could it be the Tricks board locking up and Tricks-C is curning away but the other board doesn...
What version of Vixen are you using? I had a similar problem last year using 2.5.0.8. If I would restart Vixen the problem would go away. Never cou...
TimW wrote:Would help if we could isolate the problem to the atmel chip or the 485 chip. Is the frozen panel displaying anything at all whilst froz...
Here's a poll I did last year.
This problem just keeps becoming more and more unexplainable. I tried switching power supplies from a PC power supply to a dedicated 5V 12A supply fr...
Interesting because I'm running a PC power supply. I'll have to try switching power supplies and see what happens. Matt_Edwards wrote:Last year, I h...
slyfox04 wrote:To change the delay then, do you configure it in triks.dat? I'm running into the same issue and assumed it was because the frames were...
rokkett wrote: Wait, I think I read that wrong - each channels intensity for each event time period is concatenated, then that string is concatenated ...
ctmal wrote:I believe it is stored in base64. That is correct. It is each channel's event values as a character, with each channel concatenated to ...
That did the trick. Thanks Tim!
