plasmadrive wrote:Not sure.. Not sure either are set up for HDMI to begin with.. DVI? If so you could use a DVI to HDMI adapter. I played Xbox ove...
Fppd.log and really just need the tail end of the log to see what the system was doing at the time.
Would wireless HDMI work along with a HDMI switch box at the monitor?
I don't know how this was done but it could easily be accomplished using existing midi inputs and E1.31 or DMX outputs. The site linked below is lean...
Go to the FPP settings page and set your log level to debug and check the 'all' checkbox and play a short playlist that triggers the issue and then lo...
FPP has a 595 channel output as well using the gpio pins on a raspberry Pi.
But a Raspberry Pi, install the free Falcon Player (FPP) and pick up a PiCap from PixelController.com and you can control two strings of ws2811 pixel...
FPP on a Pi can control just about anything you would use in DIY lighting as well as sACN/E1.31, artnet, etc. and runs on both the Pi and Beaglebone. ...
You may need to add a transistor to sink the current if your relay is active low. Some users have been able to make it work with the Pi without any e...
Try the Invert option on the FPP GPIO channel output and see if it makes the relay act correctly.
sporadic wrote:I started playing with Home Assistant just the other day and am adding MQTT support to my ESPixelStick code for off season usage. You h...
Thanks. Wow, that is a lot of components for one LED on the board. Ok, so only 64 usable covers/flakes. Will have to see if I have a use for them. ...
Do they have LED's on both sides? Also how big are they? If they pop apart, they could be used as-is or popped apart for 128 outdoor snowflakes with...
Is this the $29 set?
The 24:00:00 end time is actually converted to 23:59:59 internally. All end times are adjusted by one second internally to eliminate overlap and make...
