Activity
 
Notifications
Clear all
budude
budude
@budude
Illustrious Member
Joined: Oct 29, 2008
Topics: 315 / Replies: 10085
Reply
RE: e681 Dual 12v Power Supply Issue

I think RGB_Mixer has it exactly - one supply has a common DC and Frame ground and the other doesn't. I'm guessing you should be able to measure the d...

10 years ago
Reply
RE: LedTrix - One "Unlit" LED lights a complete Column - ??"How / Why"??

Re: LedTrix - One "Unlit" LED lights a complete Column - ??"How / Why"?? Why they go bad - not sure - but I believe what happens is that there is lea...

10 years ago
Forum
Reply
RE: F/S Falcon F16V2

Rick Todd wrote:... My E682 doesn't have enough power for some of my long run and F16V2 easily does it... Can you explain that? They both can outpu...

10 years ago
Reply
RE: computerchristmas.com

The last post was years ago - - pretty lonely indeed. It was my first place that I started lurking back in the day...

10 years ago
Forum
Reply
RE: Issue with Renard SS24

MikelMD wrote:Hi Brian, All of a sudden I have channel 1 on one board and channel 24 on another board (Renard SS24) go out!. Typically when my TRIAC...

10 years ago
Forum
Reply
RE: Using DMX on E682 with Vixen, How to set addresses for more than one DMX cable?

Not sure if it was clear - but you can assign 4x170 pixels on one port group and have a separate 510 channel DMX (universe) run on each port (1-1, 1-2...

10 years ago
Reply
RE: Simplest software

Definitely not Vixen 2 for pixels - there is 0 RGB support and no tools for helping with setup, etc. Now if you're talking a bunch of simple AC channe...

10 years ago
Reply
RE: Ren48LSD Woes

I think you're referring to the hex images in the file library? Those are using the standard code images with the changes spec'd in the Wiki - there i...

10 years ago
Forum
Reply
RE: Ren48LSD Woes

11Bravo wrote:After many hours, I have given up on trying to make it work which is not like me to do, However I might could continue if I could a sche...

10 years ago
Forum
Reply
RE: dual power supplies setups with e681 or e682

I run at least one or two controllers with mixed 5v and 12v - the left (don't recall which is J17/J19) is not used for logic power - only the right si...

10 years ago
Reply
RE: DC quick disconnects

You probably don't need waterproof connectors - just keep them short and put them in with the power supply enclosure. You can use Anderson PowerPole c...

10 years ago
Reply
RE: Screw type for CableGuard enclosures

The TA-200's are a different animal - they typically come with a pair of studs embedded in them and if yours did not have it, then it was sized for th...

10 years ago
Reply
RE: Points of Light

Ren48LSD with 4 outputs? How are you planning to control the motor though? Perhaps a small relay also driven by an Ren48LSD output?

10 years ago
Forum
Reply
RE: Received email on this 3d printer

arw01 wrote:Which thread? Probably THIS one...

10 years ago
Reply
RE: A little Halloween fun with FPP

That's pretty cool - and you have the right walkway up to do it right! I'm using an FPP (with DMX to Renard) to run some random dimming but nothing t...

10 years ago
Forum
Page 2 / 694
Share: