blickensderfer
@blickensderfer
Estimable Member
Joined: Dec 3, 2007
Topics: 4 / Replies: 143
Reply
RE: DIY E1.31 Bridge 6 port - initial troubleshooting questions

status update... I removed the IC9 and powered up the bridge the results were: the activity led blinked twice and the status led turned on solid. I...

11 years ago
Reply
RE: DIY E1.31 Bridge 6 port - initial troubleshooting questions

I'll look at the IC9 and can I just remove it and test?

11 years ago
Reply
RE: DIY E1.31 Bridge 6 port - initial troubleshooting questions

Dave, After the bridge was built I powered it on and only the power led came on and the wiznet powered up with network link and traffic leds. The st...

11 years ago
Reply
RE: DIY E1.31 Bridge 6 port - initial troubleshooting questions

I just built my bridge and it's doing the exact same thing. On power up the power LED is on, but no other leds flash. I've power cycled many times a...

11 years ago
Reply
RE: Networking questions

Matt, When you use unmanaged access points set on the same ssid as you are doing, they will fight with each other over your clients. The cheap acces...

12 years ago
Forum
Reply
13 years ago
Forum
Reply
RE: Needing RED, GREEN, and CLEAR Ican lights -

I think I have 3 full cases of green incan with green wire. Each case has 50 strands of 100 count and these are brand new never been used. I paid fu...

13 years ago
Reply
RE: Wireless Pixel Bridge

Any chances of using the 5GHz range? There is so many more channels available than the 2.4GHz. Bigger area to play without interference.

13 years ago
Reply
RE: Renard PX1 BETA Test

Dale, If the Renard PX1 doesn't support DMX, you could always get one of these DMX to 2811 controllers. There is a few that have ordered them and ...

13 years ago
Reply
RE: Can YOU guess what day it is?

I love that commercial.. I laugh every time it comes on.

13 years ago
Forum
Reply
RE: PICAXE + Pixels

Very cool Phil.

13 years ago
Forum
Reply
RE: Looking to add a pixel tree last minute. Is this the correct layout for my set-up?

I will probably use PVC, but I'll know for sure once I receive my shipment from Ray. They should be here some time next week.

13 years ago
Reply
RE: Looking to add a pixel tree last minute. Is this the correct layout for my set-up?

I purchased these for my pixel tree. I think these will be a little bit more waterproof with the facets. I also bought these C9 facets for them.

13 years ago
Reply
RE: F/S E681's (upgraded) and 20 Strings of pixels

He's going with a Projector...:idea:

14 years ago
Reply
RE: Carousel Build

I can see you attaching more wiper motors one on each to lift them up and down.

14 years ago
Page 2 / 10