I agree I am in the same boat. All new lights will get burned in.
I have to gree and disagree MindTrik I had have way more failures on technicolors then pixabulbs close to 50. I have had water in my pixabulbs don't ...
I'll get ya a pic tomorrow when I get up. The spray doesn't effect the color in my opinion. You can't tell. .
Yeah that should help. I'm using flex seal. They are all rubberized coatings.
Yes the test patterns worked all the time which confused me. Since replacing the two pixel where they stopped responding and moving power wires furthe...
They are pixabulbs, 12v and from controller to first bulb is 5 to 6 feet. I am power injecting at the end of the string off the same power supply. I ...
Sorry to hear about your loss Wayne, My thoughts go out to you and your family. Just lost my mom last year (Dec 10) to lung cancer. If you need to cha...
I went away from the never rustolem due to cost and I was only using the first can due to the other leaving the whole string frosted white. I using fl...
Hey all just wanted to share a test I did with a test pixel one that hasn't been out in the weather yet. I sealed it with some of that rustoleum never...
I found if I leave them run in a test pattern I have less failures so far. The pixels been running none stop for almost two weeks no failures.
Thats a bad pixel. The one that is not lit. You will have to unplug the string and cut and solder a new one in there. Pay attention to the arrows on ...
I have done that with butt connectors also. LOL
Yep solder an heat shrink.
No covers on them. I know pixabulbs have failures I have replaced about 10 pixels on pixabulbs also this year due to moisture also getting in. Some ju...
