bayhilljim
@bayhilljim
Eminent Member
Joined: Jun 5, 2014
Topics: 2 / Replies: 16
Reply
RE: How does the Color Picker work in the Curve Ediror ?

Jon, Thanks for your reply. I do understand that RGB and HSV are two different ways of expressing color. I don't know anything about Lab, but is ...

12 years ago
Reply
RE: How does the Color Picker work in the Curve Ediror ?

I'll mention from the outset that I am a newbie. I'm using Vixen 3.0.10 and I also must not know how to use this color picker. How can I specify ...

12 years ago
Reply
RE: Vixen 3 to Arduino

Is there a repository for the various sketches that you referred to? or are they just scattered throughout the forum? on GitHub? I found zparticle's...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

LightUp, Thank you thank you thank you. I just confirmed that everything is still working. Shut down the Arduino and my computer, rebooted and trie...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

OMG!!!!!!! Natale's sketch just worked as I expected it to work. I'm almost afraid to shut anything down in case I can't get it to go again, but it ...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

When you mentioned above the natale's sketch is known to work, I am not seeing that behavior. For me, natale's sketch works perfectly when using th...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

Can I run Vixen 2 and Vixen 3 on the same machine without fear of any conflicts? I can't really think of anything further to do with Vixen 3 until my...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

LightUp wrote:One other thought. In Vixen_3 did you connect each element to a GenericSerial-1, GenericSerial-2, etc in "Output Filters & Patching Set...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

LightUp, Thanks for hanging in there with me. I truly appreciate your help. I did locate zparticle's sketch on the Arduino Support Forum. He does...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

LightUp wrote: For example try a simple sketch that ignores the header and footer and setup Vixen so it too does not send a header nor footer. Now get...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

Oh, and I forgot to mention that I added a footer (~!) in the controller setup. I think this more than anything is why the relay board LEDs are flash...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

There must be something really basic that I don't understand about this software. I de/re-installed Vixen3 (64-bit) but I didn't see any changes. So...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

How do you use the Serial Monitor (I presume you mean the Arduino Serial Monitor, right?) to see what is happening with Vixen. As you said, I can onl...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

Thanks for your reply LightUp. OK, so I've been using the Sainsmart 8-channel relay board rather than NPN transistors, but I've just purchased some &...

12 years ago
Forum
Reply
RE: Vixen 3 to Arduino

OK, so I've learned what a profile is and why they exist. My problem is not there, but I still could use some help. Also, I'm not completely new to ...

12 years ago
Forum
Page 1 / 2