What am I doing wrong? I a attempting to go from 4.051 to 5.030-01. Here is my screen shot of the attempt to update. I get socket error immediately af...
beeiilll wrote:Electrical heater plugged into a 15 amp outlet in a home (more than once) that melted the outlet from overdraw. The breaker and wire wo...
mrGrumpy wrote:Need to check your code book again. A single receptacle (not a duplex) can not be a 15 A on a 20A circuit, but a duplex (which is 2-15...
This is one of the videos I took of the mega tree this year with the added star
I use rebar to anchor my base. I have clay soil and it holds very well. When it comes time to pull them out they take a lot of pulling power (aka my l...
I would be willing to pay $100 for 1 682 shipped. Let me know and I'll pay immediately. If not no problem. Thanks.
I also run a single E682 for a 16X50 mega tree. One cable to each of the 16 ports on E682.
A few pics during the day:
This was my lazy attempt. I mounted enclosure to backer board and then backer board to emt pole hammered in ground. I drilled holes through the back o...
Here's an example of flange installed on topper. This is mine that I use with an ASAP pole. I also have a star. I attached the star to a 3/4" pole ...
guy wires will help correct. I use a guy wire from the back of my topper to the ground to keep things straight front to back.
Abandoned adding tutorial due to the changes that xLights scheduler went through this year. I am still using old version of built in xlights scheduler...
Second year underway. Setup tree on Saturday just before first wind/snow event of the year. I'll post a daytime picture at some point of the setup. Th...
For the time being, if you're in a crunch, you could always download an older version of xLights with the old scheduler built in and use that for your...
