angus40
@angus40
Illustrious Member
Joined: Dec 25, 2011
Last seen: Nov 18, 2026
Topics: 1177 / Replies: 7340
Reply
RE: 3D canes

tfischer wrote: Like Ernie, my thought was that a cap would only be needed to keep the pixels in place (for these demos they were just shoved in lol) ...

7 months ago
Reply
RE: 3D canes

ErnieHorning wrote: I'm only intending to add a cap as a tie point for the pixels. I'll create 1 for that purpose . Maybe a hoop inside the cap sho...

7 months ago
Reply
RE: Snap together Stars

tfischer wrote: Thanks! Thes store almost completely flat, which is one reason I like them. A similar, but quite different project I did last year w...

7 months ago
Reply
RE: 3D canes

Does the end of the cane require a cap or 1/2 a connector to diffuse evenly ? My intent with that design was a press in cap that would give a better a...

7 months ago
Reply
RE: Icicle sequencing on pixels

ErnieHorning wrote: Well according to the overly optimistic side of ChatGPT, this is totally doable through WLED. It would be a continuously running ...

7 months ago
Forum
Reply
RE: Snap together Stars

tfischer wrote: I have a star model somewhere that I made a couple years ago when I converted some former commercial spiral trees to use seed pixels. ...

7 months ago
Reply
RE: Icicle sequencing on pixels

Ernie , Thank you for the quick and detailed replies . This gives me a ton to consider . I'm unable to get into anything for a week or 2 as I'm back ...

7 months ago
Forum
Reply
RE: 3D canes

tfischer wrote: As a comparison, I ran a similar demo using one of my PEX-A canes. Ignore the extra bend at the bottom, that was from the bending test...

7 months ago
Reply
RE: 3D canes

tfischer wrote: OK we finally got a test cane printed! These are pretty nice. Here's a demo video. This is using 4" spaced seeds, folded in half such...

7 months ago
Topic
Forum
Replies: 50
Views: 4629
Reply
RE: 3D canes

I use this build plate and print directly . No glue , No adhesion settings at all . Once i dialed in the level and z height its a dream to print on, ...

7 months ago
Reply
RE: Snap together Stars

I have a 20 pixel star complete if there is interest . its a 1 piece print with holes in the back for bullets or squares. this is untested as my prin...

7 months ago
Reply
RE: 3D canes

Things to try bed temp 80 - 85 reduce cooling fan to 50% adjust z to slightly skim paper with drag model setting depth to plate -0.01 print the test...

7 months ago
Reply
RE: Snap together Stars

Here is the final design on this star . Depending on cost , I'm considering having through hole pcb's made up as the insert-backing similar to my a...

7 months ago
Reply
RE: A new Star Design

Like Asian tapestry intentional flaw ! 2 leds for the good guys .

7 months ago
Forum
Page 6 / 569