Aurbo99 wrote: On your e682 you have; Universe 1, Channel 1 to Universe 5, Channel 360 configured for your MegaTree (2400 channels) On your xLights ...
I have to give up.. the E682 controller just went south for the winter. 2 yellow lights are only on now, rebooting will not correct it, I can not get ...
Aurbo99 wrote: Check fuse1 (F12) re-seat IC5, IC9, RN1-2 I did all the suggestions you stated, (except re-seating the Resister Network) they are sol...
I figured out that port 1 and 2 on the E682 is not working, but port 3-16 work. the Fuses are good.. Its getting power from the J18 - J19 Plugs the A...
Aurbo99 wrote: it appears you have the E682 controller set to test pattern 4 which will override incoming data Change it to 0, and use the Update Sys...
memphislights2 wrote: Stop and breathe. Disconnect all off the lights from the E682. Try resetting the E682 to base configuration and then see if you...
I tried to upgrade the firmware, status is times out. (i renamed the file and it's in the same directory) I tested the strings on a WLED controller...
I think my E682 controller is bad.. it fried all of my strings, 16 strings, 800 LEDs, they are all Super hot, and the first LED pixel is dimly lit. I ...
MartinMueller2003 wrote: You do not specify what is not working. Have you run the test mode on the controller? Do the lights respond properly? After t...
XLIGHTS Settings
I have been trying to get this to work for 2 weeks now, and nothing. Xlights might not be the way to go. I have such a simple setup, why is it so har...
Any places you know of the get starter sequences from
Should I wire this up in series or each string wored back to the controller?
I have been trying to make some Ws2811 Pixel Flood Lights, my main issue was a waterproof case to use outside. I have not had any luck in finding a pr...
