The wires for my mega tree(12ft) are permanently strung on rewire.
Four panels are hooked over a top ring and placed in an octagon configuration with the back two panels missing.
Two pieces of 1/2 inch rebar hold each panel a foot off the ground.
In the off season the panels are stored flat against a wall withe the lights still on them.
No tangles.
No stretched cords.
Let the wind blow, this design is unaffected.
Joel
Re: Converting a Basketball Goal into a megatree
TonyK wrote:If anyone is interested I can post measurements and complete instructions on how to build this.
Yes, please do so.
Thanks.
\dmc
As everyone has different Idea's on their mega tree I thought I would show off my ever evolving design.
The pieces consist of:
1 6inch wood bun
20 1.5 inch wood eyelets bent open.
2 3/4 in floor flanges
2 1 inch machine thread eyelets
1 8 inch 3/4" pipe
2 10 inch pieces of fiberglass
1 1.5 inch sink drain pipe 2 inches long
lots of epoxy
Start by slightly bending open the 20 eyelets. Then screw each on in to the wood bun working around the circle trying to keep them even. I used an across method. One across from each other until I had all 20 in. After all the hooks are in mix epoxy and cover the entire bun in a thin coat and work 1 peice of the fiberglass on top. Cut the fiber glass cloth to go around the hooks. When on side is dry complete this step on the other side. Your wood bun is now a reinforced wood bun. After the epoxy dries mark the center of the wood bun and drill a 1.5 inch whole in the middle of the epoxy covered wood bun. Cut a piece of sink drain pipe to fit inside the wood bun and stick out about 1/4 of and inch on each side of the bun. Now starts the messy part. Mix up a big batch of fiberglass resin and pour it over the top of the bun put a thick layer on it but do not cover the top of the drain pipe. Let it dry and repeat on opisite side letting the epoxy put a thick coat on the wood bun. Now you have a light strand holder for your tree.
Now take the 2 flanges and screw them together with the machine thread eyelets. Screw in the small piece of 3/4 in pipe make sure the pipe is on the side with the eyelets openings.
The next step is to decided how tall you want your mega tree. I use chainlink fence top post. To mount your tree toper place the end of it in the fence post. Select the heigth of tree you want and guy wire it from the top. Use some 3/8th in rope to run through your bun up to the eyelets pointing down then back to your bun. This is the raising mechanism. Attach your light strands to your hooks and hoist them up.
I use this design on my 16 ft tree with 60 strands of lights and raise it by hand. The strings are heavy and may requre some help to raise them with out a wench.
Pictures are attached an you can see my mega tree in my photo album.
Nice pics RichF
I'll be stealing this design for my Mega tree next year =)
One change I can see is to replace the 3/8" rope with 1/4" braided steel cable used for garage doors or other things, and use a ratchet or "come along" from a cargo tie down strap, band clamp it it the pole near the base and you have an inexpensive hand winch.
A cable eye with wire cable clamp can add extra safety/lock point.
A simple pull on the ratchet will tighten up or a flip the lock level and slack it off.
I'm sure it wouldn't take much from the other guys here to figure out a way to mod it to a crank or wrench turn if you want to go that way too.
I plan on a ratcheting wench next year. I did not think about the garage door cable. Looks like I will be making some changes. If anyone needs any more pictures let me know.

