Does somebody make ...
 
Notifications
Clear all

Does somebody make these?

8 Posts
2 Users
0 Reactions
4,641 Views
Posts: 138
Topic starter
(@jeffro)
Estimable Member
Joined: 16 years ago
[#23892]

I'm looking for 3-way corner connectors that can hold 1/4" or 3/8" metal rods together. Something like the 3-way corner PVC connectors, just built for metal rods.

I've seen them before, they're usually hard plastic or rubber. Any suggestions on where to find them, I'd greatly appreciate it!


7 Replies
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

I'd venture that someone makes a 1/4-20 T-Nut or T-Connector of some kind. That or get the 1" long threaded nuts for connecting all-thread together and weld 2 or 3 of them together and make your own they are cheap enough.


Reply
Posts: 138
Topic starter
(@jeffro)
Estimable Member
Joined: 16 years ago
chelmuth wrote:I'd venture that someone makes a 1/4-20 T-Nut or T-Connector of some kind. That or get the 1" long threaded nuts for connecting all-thread together and weld 2 or 3 of them together and make your own they are cheap enough.

Yeah, I thought of that but I'd like to break these down for storage when not in use. If I weld them, they're in that connection permanently.


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

I was saying just weld the two nuts together and then screw the metal into the nuts..


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

maybe you could tap out something like this http://www.weiku.com/products/6008504/Banjo_Hydraulic_fitting_amp_adapters.html


Reply
Page 1 / 2
Share: