Newbie question:
1. Can xLights be used to sequence incandescent light strings on wireframes?
2. What is the missing hardware in the following control flow diagram:
Falcon F-48 controller > Falcon differential board > ???? > 110VAC light string
Thanks for pointing me in the right direction.
Dick
Hi Dick,
Welcome to the Madness of Holiday Lights.
xLights can definitely be used to sequence incan light strings. You need to add an AC controller of some type to your system I personally use Renard boards (You should be able to pick up something used off the Buy/Sell forum at a good price). While I CAN run them off of my F-48, I choose to instead have my Raspberry Pi (Show Computer) directly connected to both my Falcon and Renard boards.
How many channels (different AC strings) are you looking to control?
Greetings Tom!
I have not heard of Renard boards, just found another research project!
Since you confirm an AC controller board will be required, my research will focus on identifying the best type of light strings and AC control board first. I can then work through the best way to control them.
Thanks for your response and assistance in identifying the problem that need to be solved!
Dick
Greetings Mike!
Appreciate your response to my question.
I did not realize the Falcon F48 supports Renard boards directly instead of through the differential receiver board. I am guessing that the Renard boards are controlled by DMX, so any of the three DMX RJ45 jacks may be used to control them.
Did I get that right?
Regards,
Dick
Check out the manual for the F48 ( https://docs.google.com/document/d/1sAzoFztiKdI3BPDl_Kegu28DKKlIM4PlSNaCNvvDtgk/edit ) page 16 (Section 3.2.3).
Renard is its own protocol that also uses RS-485.

