I have some old wire frames I am looking to redo for 2025. I am considering something like DC 12V Neon Strip from AliExpress and I am curious if anyone has worked with it before.
- Biggest concern, is it bright enough for a Christmas display?
- Is it as flexible as the vendor indicates?
- From a cutting/splicing perspective, how difficult is it to work with?
- How long does it last?
Thank you for any input
-Tony
This is far too late for you this year... but I will give my experiences so far:
1) Yes, all the ones I have used have been plenty bright. In fact, I need to dim them in order to make them reasonable with the other LEDs, inflatables, and such in our display.
2) Rarely are they as flexible as a vendor says but it can depend on your needs. If you have mostly curves and do not mind "soft corners" on angles, they can work out just fine. I have not used any of the (more expensive from what I have seen) ones that are specifically designed for side-side bending versus generic ones.
3) Cutting is VERY easy as long as you cut at the specific points labeled, they are usually correct. Splicing can be a pain. When you cut, assume you are going to loose more off that end (unless it is specifically an end). When you splice, depending on how sealed up the LEDs are, you may have to do some fair amount of cleanup to be able to solder to the pads on the strip and the pads are always nice and small. Then you have to seal it all back up again. I find that usually interferes with the previous set of LEDs at least somewhat, so I just count them out entirely.
4) That varies unfortunately. I had a brand new strip stop working partly through a season last year and it failed right by the beginning of it. The other strip on the same decoration continued fine. Another set (that includes one the same as the one that failed) is continuing just fine this year. Strips I have used similar on other stuff have continued to work for years. There are MANY strips out there and quality can vary a lot. I never figured out what caused that one to fail. I have a mix of fixed color strips as well as controllable color strips (and addressable strips). All of them feel roughly the same in terms of general durability and such. I would expect the single color strips to survive longer because they are simpler. Also, I realized this is a factor... I am in upstate New York, by Lake Ontario... so we can get "serious" winter here as well as high winds.
I bought a couple neon strips from Amazon. So far, I've only plugged it in to test. It was very bright. Most of my pixels are running at 30%, so it would certainly be plenty bright for me.
I've seen video's where they recommended using a heat gun for tight bends.
Thanks! I’ve got a few done already. One important tip: don’t forget about voltage drop, and make sure to run the strips in parallel.
Those neon strips look unidirectional, whereas seeds are omnidirectional. What are you thinking about that? Are you thinking 3d wireframes? I've seen several neon strips on Ali that are omnidirectional.
