Advice needed for a...
 
Notifications
Clear all

Advice needed for a wire frame

11 Posts
7 Users
0 Reactions
6,229 Views
Posts: 64
(@smallcrpt)
Trusted Member
Joined: 16 years ago

Yeah any strong epoxy for metal. There's a few different ones available at home depot. Very easy to use and hold extremely well.
Good luck


Reply
ChristmasBuddy
Posts: 452
Topic starter
(@christmasbuddy)
Honorable Member
Joined: 14 years ago

Mucho Thanks! Home Depot is my friend.

Buddy


Reply
Posts: 99
(@sulrich)
Estimable Member
Joined: 13 years ago

if you use aluminum, a simple propane torch from home depot will handle alumiweld from Harbor freight. Torch $45, alumiweld $15 (Before 20% coupon), best prices on aluminum i found was metalsdepot.com.. simple to use, plenty of youtube videos on how to use it. just make sure the metal is plenty hot and dont melt the alumiweld with the torch. heat the metal until when you touch the stick to the metal it flows. It makes a strong bond (20,000 psi strength i heard/read somewhere)


Reply
ChristmasBuddy
Posts: 452
Topic starter
(@christmasbuddy)
Honorable Member
Joined: 14 years ago

I definitely want to get into some level of welding but I'll wait on that. Thanks for the info though. I'll try the epoxy path first.

thanks!

Buddy


Reply
THurrle
Posts: 1211
(@thurrle)
Noble Member
Joined: 17 years ago

Looks like you got a bunch of ideas which were good. If is is aluminum you would not really be able to wled it with a mig. I hear it can be done but not v\real easy. I would get yourself and Harbor freight mig with gas to start. i have a 220 volt one from there and am in my fifth year with it and only reached duty cycle one time. I build a number of frames each year. With a little practice you with master it in no time. I had never used a mig and it was not hard to do.
Terry


Reply
Page 2 / 3
Share: