Patching Channels -...
 
Notifications
Clear all

Patching Channels - Start channel

6 Posts
2 Users
0 Reactions
2,566 Views
Posts: 90
 kevr
Topic starter
(@kevr)
Estimable Member
Joined: 17 years ago
[#29662]

I have made some test sequences in 3.0.10 and am able to display them working in the preview but I can't get my head around how to assign the start channel of the controller that they output to?

I am using several DMX 3 & 16 channel controllers & also E1.31 units. When I look at the properties for the controller I see the location dialogue displayed for a single color controller is this where I set the channel?

Also when you are using DMX after selecting this in the controller list is there no need to assign the comport you are using?

Kev


5 Replies
Posts: 90
 kevr
Topic starter
(@kevr)
Estimable Member
Joined: 17 years ago

I read and I read and I couldn't work this out and then I found this post and I finally get it, I think!

So I need to forget my old habbits and list my DMX as a single controller 1- 512 if I only have 1 universe and a second may be 1000 - 1512?

Cheers Kev


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 19 years ago

Each "controller" should be configured, in vixen 3, with channels 1-XXXX, XXXX being whatever the last channel on that controller is. For example : 4 E68x controllers. Each one is set up to have 2016 channels. Each E68x controller in V3 is configured to start at Channel 1 and end at Channel 2016. Each controller is its own entity.

If I misunderstood your question let me know.

Here are some screen shots for the E68x series controllers. I do not have a com port on this machine so I can not setup a DMX controller directly. But maybe the screen shots will help.

1
2
3
4

Reply
Posts: 90
 kevr
Topic starter
(@kevr)
Estimable Member
Joined: 17 years ago

Thanks for the explanation Brian.

I think I have the E1.31 sorted but I not 100% on the DMX controllers, with these do you add 1 single controller DMX universe and then map to the channels?

I have been using Lynx MR16's for our 24v DC lights in New Zealand for a few years so I am prety familiar with Vixen 2.0. I am use to building the gear and then setting a start address for each controller.

Kev


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 19 years ago

Will the DMX controllers run off a single dongle? If so then they should be a single universe and the channels would be 1-512 or however many you are using. The DMX controllers will have to be configured with their respective channels as well. Unless you are utilizing something I am not familiar with.


Reply
Page 1 / 2
Share: