Notifications
Clear all

Initial Setup

4 Posts
4 Users
0 Reactions
2,265 Views
Posts: 3
Topic starter
(@gadget5000)
Active Member
Joined: 5 years ago
[#55406]

Hi,

I am new to Vixen and I think I may be getting the wrong end of the stick on the setup with an Audrino Uno and a 16x relay board

I have setup the initial with Single items and mapped to Outputs on Generic serial and set the curve to a single colour as all the sequencer need to do is On and Off work.

I have coms to the Audrino and it goes into random mode until I fire up Vixen then that stops and I can see coms traffic on the tell tale light on the audrino...and this is where stuff stops...

No matter what effect I add it is gray (as in the effect graphic is not the one I added) and there is no response from the Relays at all...

Any pionters would be fab.

Cheers


3 Replies
Posts: 156
(@mr-fix)
Estimable Member
Joined: 6 years ago

not all effects will work with this set up as most are for the pixels but if you creat a groupe for all your elements yoi can us more of the effects i have Then doing this since I began last year in this year.
Set your elements as groups example roof line lights tree lights Put your sections into different groups and then create one group with all of them inside so when you use your elements it will use it as a whole together.
sounds like your setup is good
try some simple lights on then off Randomly not even according to the music just to see how the lights react The solid color ones Remember curve all the way down near the side curve all the way up.
Sent from my SM-N975U using Tapatalk


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

You are using Victor_PV sketch as noted in another post. You may need a header. Show us a picture if your Vixen controller config window.


Reply
jeffu231
Posts: 2457
(@jeffu231)
Famed Member
Joined: 15 years ago

If the effects render as gray in the timeline, then something is wrong with the setup. Set Level is going to be the main effect you will be using for on off type setup. In the Display setup, you can run through the Color Handling setup again for each element. Ensure you choose single color and change it to something other than the light blue it defaults to. You can use white or the actual color of your string attached to the element. Then go back and see if the effect renders in the color you choose. Then from there you can validate data to the controller.


Reply
Share: