I have a problem and can’t figure it out. I am sequencing in vixen and I can output to my controller and everything looks great. I export to FPP and I am seeing chase effects and others starting and stopping in different elements? It’s like it’s channel shifting when running some effects like chase?
Any ideas cause I have tried going back to v1.8 on the FPP but same problem. I guess I could use the computer to run the show this year from Vixen but that is far from ideal. 24 hours till start time and I am calling in all help out there.
Thanks in advance
Sent from my iPhone using Tapatalk Pro
Sounds like a mapping issue in FPP. How does your Vixen controller configuration ("display setup" in Vixen) compare to the FPP channel output settings?
Here is what I have set up. 3 controllers total of 12 universe. No universe is repeated and each controller is set up with sequentially numbered universes. I tried a second pi as it flashes and drops out like bad data. I’m running just a single new good test string of lights off one controller. Output from Vixen is perfect. From the pi a mess.

Sent from my iPhone using Tapatalk Pro
Try this. When you are running a sequence/effect of FPP, make sure Vixen is shutdown (close the entire application). Even if Vixen is not playing there is some kind of background traffic to the controllers that interferes. That should eliminate rapid blinking.
Also changed your FPP mapping so that universes 1-4 are Unicast to 192.168.1.206, 5-8 to 192.168.1.207, and 9-12 to 192.168.1.208. See what happens after you do that.
