Notifications
Clear all

Gradient Help

7 Posts
5 Users
0 Reactions
2,189 Views
Posts: 79
Topic starter
(@blackramair)
Estimable Member
Joined: 12 years ago
[#35479]

I can't seem to figure out the correct way to make a gradient. I choose my first color then slide the slider to a location of say 25 then select another color and only end up with the last color I selected. Please instruct me on the proper way to perform this action before I go crazy. Thanks in advance


6 Replies
jeffu231
Posts: 2456
(@jeffu231)
Famed Member
Joined: 15 years ago

Sounds like you need t add another point for the second color. Click below the gradient bar where you want the next color point to be. You can then set the color of that point.


Reply
Posts: 79
Topic starter
(@blackramair)
Estimable Member
Joined: 12 years ago

Thank you so much. I have played with and searched for hours trying to figure this out. I really feel like a dummy now.


Reply
Posts: 206
(@tallahassee-dreamer)
Reputable Member
Joined: 17 years ago
blackramair wrote:Thank you so much. I have played with and searched for hours trying to figure this out. I really feel like a dummy now.

You should not feel like an dummy " YOU DON'T KNOW WHAT YOU DON'T KNOW"


Reply
Posts: 88
(@matree)
Trusted Member
Joined: 14 years ago

Its easy once you know it, but its not obvious nor intuitive that you need to just click below the slider to get another point on the slider. Documentation is sparse and I had the same frustration with it until I stumbled on it by trial and error. Even then, I still find the color choosing to be very dubious and non-intuitive. The inability to set all 3 of the RGB values frustrates me every time (you can choose any two color values and Vixen overrides you on the third)


Reply
Page 1 / 2
Share: