cannot patch to out...
 
Notifications
Clear all

cannot patch to output

3 Posts
2 Users
0 Reactions
1,245 Views
JCook
Posts: 1003
Topic starter
(@jcook)
Noble Member
Joined: 13 years ago
[#39623]

I'm trying to patch 72 outputs. I have 8 floods set up, all of the patched fine but this one will not patch. the outputs I'm trying to used are not patched. I dont see any difference in the setup of this one versus the others.

Here is a screenshot.

patching

2 Replies
Posts: 99
(@mazobob)
Estimable Member
Joined: 13 years ago

The controller must not be defined properly. It says 1 output. Doesn't the E682 have a limit of 6120 in unicast, and 3570 in multicast?

EDIT: the picture also shows #8940 in the description of the controller. Is it possible to you are highlighting a specific port instead of the controller at the root level when you are trying to patch?


Reply
JCook
Posts: 1003
Topic starter
(@jcook)
Noble Member
Joined: 13 years ago

I think the issue was they were patched in the wrong place so I un-patched/re-patched seems to be fine now.


Reply
Share: