I know nothing about writing plug-in’s but I understand that plug-in’s are created with C#. Here’s a site that describes writing an X-10 library for the CM11A (Firecracker). It may at least provide an example how the CM11A should be controlled.
http://www.15seconds.com/Issue/040413.htm
If it turns out that this is useless, well… it’s free.:-|
I would be willing to test any X-10 plugin someone creates. I have a house full of them, and several computer interfaces also.
- Michael
I would like to see an X10 plugin also.
But, I have used Vixen to control the X10 modules with a little creativity.
I am using the CM11A contoller (still working on reliablity issues by adding a phase coupler and repeater, but that is another story). I have installed Active Home and made sure it was communicating and controlling the X10 modules correctly.
I also had to configure the serial port to COM4 (and the Active Home software to COM4) because leaving it on COM1 caused issues with Vixen.
-----------
First create two channels for each X10 module, an ON channel and and OFF channel. Example Ch.1 = Module E1 on and Ch.2 = E2 off.
Then use the Launcher plugin and configure one Launcher instance for Ch.1 only and another instance for Ch.2 only. So the Launcher plugins should be configured as such:
Launcher (instance 1)
Channels = 1 to 1
Program Executable Path = C:\Program Files\Home Control\x10comm.EXE (assumming active home installed and located in the default directory)
Parameters = E1 On
Trigger Level = 100% (I used the default for this one)
Launcher (instance 2)
Channels = 2 to 2
Program Executable Path = C:\Program Files\Home Control\x10comm.EXE (assumming active home installed and located in the default directory)
Parameters = E1 Off
Trigger Level = 100% (I used the default for this one)
To turn on X10 module E1, turn on Ch.1 for a short duration (500 ms should be sufficient).
To turn off X10 module E1, turn on Ch.2 for a short duration (again, 500 ms should be sufficient).
The X10 modules have a turn on and off delay so you will have to learn your system and program your sequence accordingly.
My method is a little cumbersome but I think it will work good for what I need it to do without the learning curve of plugin module programming, debugging, etc!
Hope this helps!
Hahaha...great to see this again! Did you ever figure out another way to do this? Might just use this again to fade out the carriage lights on the house during songs.
ITs just x10 is too slow 1-2 sec to turn of and on or dim a level.(up or down)
Also the x10 adaptor is just a serial modem you can probably figure it out pretty easy.
