PSC plugin compatib...
 
Notifications
Clear all

PSC plugin compatibility.

34 Posts
3 Users
0 Reactions
21 K Views
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

Did the code change a help or not? If it didn't make a difference you can find the shipped version of the code here http://www.parallax.com/Portals/0/Downloads/docs/prod/prop/PSCPropellerFirmware.zip


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Stgtech wrote:I was able to re-create the described situation. So long as there are no "on" values in any of the blocks in the Vixen sequence, it will run without a baud rate error. I can see blue led blink twice before it runs which I assume is the Vixen baud rate query. \

Without a good way to test this stuff I'm shooting blind. Further KC can't really make code changes without a PSC to test against. I'm starting to run out of options.


Reply
Posts: 47
Topic starter
(@stgtech)
Trusted Member
Joined: 19 years ago

From what Parallax tells me. Now that I'm able to update the firmware I should be able to enable a "echo" that is similar to how the older board functioned. With that in mind, I am going to download the firmware you linked too released by them and attempt to figure out how to enable this feature. I'll keep you posted.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Stgtech wrote:From what Parallax tells me. Now that I'm able to update the firmware I should be able to enable a "echo" that is similar to how the older board functioned. With that in mind, I am going to download the firmware you linked too released by them and attempt to figure out how to enable this feature. I'll keep you posted.

Hold on a minute. I've looked through the code and there is no "echo feature." To make any changes you will have to be familiar with Propeller's spin coding language, its not as simple as just enabling something. BTW the code I posted was echoing, you can verify that with a serial terminal.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

I can't seem to reach you off forum so I will try posting the code here.

KC has been kind enough to remove the auto baud portion of the PSC code. This plugin is locked at 2400 baud. Please try it with the Prop PSC (the code it ships with not my modified code) and let me know what happens.


Reply
Page 5 / 7
Share: