PSC plugin compatib...
 
Notifications
Clear all

PSC plugin compatibility.

34 Posts
3 Users
0 Reactions
21 K Views
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Stgtech wrote:That is odd. In both the PSCI app and the Propeller Tool Program when i query the version number I receive a version 1.0 response.

I guess there is something wrong with my propeller PSC emulator. With that being the case, and if you are feeling adventurous, give this firmware a try.


Reply
Posts: 47
Topic starter
(@stgtech)
Trusted Member
Joined: 19 years ago

I'm slightly confused as to exactly how to flash the new firmware to the unit using the prop tool.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Stgtech wrote:I'm slightly confused as to exactly how to flash the new firmware to the unit using the prop tool.

Open "PSC Propeller Firmware_1_1.spin" in Prop Tool (development environment))

Set the jumper on the PSC board

In the Prop tool you can press F11.


Reply
Posts: 47
Topic starter
(@stgtech)
Trusted Member
Joined: 19 years ago

Uploaded the new firmware. The green light indicating data now remains constant with Vixen open, however I'm still getting the baud rate error. =/ I can't be sure, but I felt like the first time I tried it Vixen ran without the baud rate error, but when I stopped the sequence to add some actual values into the blocks, then restarted the error re-appeared upon play. I restarted Vixen and the baud rate error still remains. I can't be sure it ran correctly the first time though... Time makes one doubt oneself. Hope this helps,

Aaron


Reply
Posts: 47
Topic starter
(@stgtech)
Trusted Member
Joined: 19 years ago

I was able to re-create the described situation. So long as there are no "on" values in any of the blocks in the Vixen sequence, it will run without a baud rate error. I can see blue led blink twice before it runs which I assume is the Vixen baud rate query. \

Aaron


Reply
Page 4 / 7
Share: