I have an Enttec USB Pro connected my PC to control some DMX stuff. The converter works just swell with Light Factory but will not operate with Vixen. The error message says "cannot find COM1". I have tried to solve the com issue but have been able to. Any help?
Are you completely sure the dongle is coming up as "COM1"? If you remove it, you should not see it in the Device Manager port list - and of course when you pop it in, a new one should show up... Sometimes Vixen likes the thing woke back up so try cycling it down/up before starting Vixen. Also - is it possible some other driver is still using it (like Light Factory)? Perhaps there's some background SW that grabs it when it comes up? Just thinking out loud...
edit - Oh - - and Welcome to DIYC!
leko wrote:I have an Enttec USB Pro connected my PC to control some DMX stuff. The converter works just swell with Light Factory but will not operate with Vixen. The error message says "cannot find COM1". I have tried to solve the com issue but have been able to. Any help?
Are you using the DMX Pro plug-in in Vixen?
I'll attach a PDF file that may help you with setting up your Enttec dongle with Vixen.
It's written for my DMX-Pro clone dongle, but the Enttec uses the same drivers and setup that mine does, so it should be applicable.
Robert
