Borrowed Sequence
 
Notifications
Clear all

Borrowed Sequence

7 Posts
6 Users
0 Reactions
2,857 Views
gweedojg
Posts: 55
Topic starter
(@gweedojg)
Trusted Member
Joined: 16 years ago
[#14696]

I have watched all the How to Videos on Vixen. Are there any tutorials on adjusting borrowed sequences? For example How do I input my house for preview or what if the sequence has a mega tree with 45 channels with three colors but I want just 16 channels with two colors. I tried clearing the channels on the sequence I borrowed to 16 channels but when i played it, the mega tree only lit up partially. Any advice or a point in the right direction will be appreciated. johnny:confused:


6 Replies
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago

to borrow is pretty simple ..copy and paste the area in you sequences and adjusted them as you wish ...i hope it help
cheer


Reply
Posts: 157
(@smoothice)
Estimable Member
Joined: 17 years ago

I think it may be easier to set up your adjustable preview and profile first. Then import pieces of a borrowed sequence into it.


Reply
Posts: 39
(@lineman)
Eminent Member
Joined: 17 years ago

open up the borrowd seq, and then open up your seq you should have both seq opened in the same vixen then copy what you like in the borrowed seq, ( copy to clip board ) then paste to were you want it in your seq. ( Paste from clip board )


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
lineman wrote:open up the borrowd seq, and then open up your seq you should have both seq opened in the same vixen then copy what you like in the borrowed seq, ( copy to clip board ) then paste to were you want it in your seq. ( Paste from clip board )

Make sure the interval timings are the same between the source and target sequence before cutting/pasting otherwise the overall timing will be off.


Reply
Page 1 / 2
Share: