Vixen gives error m...
 
Notifications
Clear all

Vixen gives error message when running a program with multiple sequences

18 Posts
10 Users
0 Reactions
8,306 Views
Posts: 49
Topic starter
(@brad2157)
Trusted Member
Joined: 18 years ago
[#13113]

I built a program with my first two sequences in Vixen 2.1.1.0. I am not sure I created it correctly, but when I go to "Programs>Manage", highlight my program name, and hit the Play button, it will play my first sequence fine. After the first sequence plays and is over then I get this error message below:

Renard Dimmer (modified):

(Router - Startup)

Access to the port 'COM1' is denied.

Any ideas on what might be causing this? I am trying to get my two sequences to play and loop until I stop it on the show PC.


17 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Go to your program screen, make sure the "cross fade" setting is zero. It will cause that error every time if it's anything other than zero.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Check to be sure that your seconds of 'cross fade is set to '0'. Anything higher causes a Com Port error.

Darn, the Dirkster beat me to it again.....................


Reply
RichF
Posts: 1356
(@richf)
Noble Member
Joined: 19 years ago

If your using a program make the progam have the output setup and disable it on each sequence.


Reply
tweist
Posts: 394
(@tweist)
Reputable Member
Joined: 18 years ago

I have the same problem, I built a program with 5 sequences in it. The cross Fade is set to zero. And all of my sequences use a profile for setting up the plugin outputs. I also select the "use profile" radio button to indicate which profile to use.
I put the program in the scheduler and it starts just fine, runs for an hour or so and then comes up with the "Access Denied" popup.
I have also tried two different operating systems and two different computers. Both have the same problem.

I'm open for suggestions.


Reply
Page 1 / 4
Share: