I installed Windows 7 on a old XP machine that I used to run the run last season. This machine has 2 gigs of memory and I also had a PCI USB card in it. I had some issues with last year. I don't recall what I did to make it run.
Now it is back again. I can get a single sequence to run alone. But when I want to run a schedule, it will freeze after the first sequence. I messed around with the COM Ports last night. I messed up COM Port 5 where it wouldn't start anymore. I put another Xbee on the Cable and was able to get COM port 3 up. I still hangs during the schedule. Arrgh! There must be a remedy for this . But how and where?
something else I don't understand is about the Universal serial bus controller versus the COM PORT.. When I install the PCI card it shows up under Universal bus controller. Are the COM ports and USB controller related?
Try running your vixen sequences through the program XLights. Ive had scheduler problems in the past and using xlights scheduler fixed my freezing
Trav
I had a similar issue once, I had to go back and re-attach all of my sequences to a profile after I got the profile to work. Make sure you back up your sequences before making any changes to your files. Also, make sure the com port you are using is set to the correct baud rate, etc.
This thread might be of some use. I think post #26/#27 are talking about like what Keith said.
http://doityourselfchristmas.com/forums/showthread.php?5286-Access-to-Com-Port-Denied
Shut down vixen. Then go to Windows Task Manager and look at at processes running. Look to see if there is an instance of vixen still running. You may have a second instance of vixen running. End that process if it is running. Then restart vixen.
