Program problems
 
Notifications
Clear all

Program problems

7 Posts
4 Users
0 Reactions
3,260 Views
zztopmo
Posts: 288
Topic starter
(@zztopmo)
Reputable Member
Joined: 17 years ago
[#12161]

Just when I thought I had this licked another problem comes up. When I go to set up my program I give it a name then drag and drop the sequences I have set up. All of them have the plugin setup in each one. I click use the sequences plugins and then I test the program. The first sequence kicks in with no problem. The the next one pops up and says either the ren cannot connect to com1 or one plugin has to many channels and must be fixed. I have 0 on the fade over and when I check my sequences on a individual basis the setup is correct. What am I missing?


6 Replies
RichF
Posts: 1356
(@richf)
Noble Member
Joined: 19 years ago

Remove the plugin from each sequence and select the top radio button "use programs plugin setup" for the sequence. set up the plugin as you would for each sequence.

your problem occurs because Vixen tried to overlap the sequences.


Reply
zztopmo
Posts: 288
Topic starter
(@zztopmo)
Reputable Member
Joined: 17 years ago

I did that just now and it say access to com port denied


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Make sure there are no phantom copies of Vixen running (check Task Manager) and if you are using a dongle, unplug/plug it in then start up Vixen and try again.


Reply
zztopmo
Posts: 288
Topic starter
(@zztopmo)
Reputable Member
Joined: 17 years ago

I am running one ren24 and an 8 channel basiccontroller. When I do them in a sequence by thierseleves works great. Only in the program does it goofy.


Reply
Page 1 / 2
Share: