problem with vixen ...
 
Notifications
Clear all

problem with vixen lock up

4 Posts
2 Users
0 Reactions
2,021 Views
Posts: 126
Topic starter
(@joshlisa)
Estimable Member
Joined: 19 years ago
[#13225]

Hi and thanks for reading.

I am having some trouble with running "programs".
I can run all my sequences alright but when I try to run the program I get vixen to lock up saying something along the lines of "port already in use".
The problem doesn’t seem to happen at the same time in the program either.
I have a PCI serial card with 2X comm ports on it. I was trying to run (for the first time) a ledtrix board with tricks c and (also for the first time) a ren c card with olsen 595. I also have 5x olsens running off a parallel port that is onboard the computer.
I have tried turning off the Tricks and have even disabled the second comm port just in case. Like I said above I can run the sequences OK but just not once they are in a program. Vixen seems to lock up due to the pop up dialogue box with the error message.
Any suggestions as where to start looking for issues?

Josh


3 Replies
Posts: 89
(@rickeys)
Estimable Member
Joined: 19 years ago

I had that happen to me also, my problem was on the program manager screen I had to leave the seconds of cross-fade between sequences set to 0.


Reply
Posts: 126
Topic starter
(@joshlisa)
Estimable Member
Joined: 19 years ago

Thanks will give it a go.

I realise I was a little vauge but the error was as follows...
" renard dimmer (modified):
(router - startup)
Access to the port 'com3' is denied."

hope it is as easy as your fix.

Josh


Reply
Posts: 126
Topic starter
(@joshlisa)
Estimable Member
Joined: 19 years ago

Well Rickey that seems to have done the trick.
Need to run the show tonight but ran it for a while today with no issues.
Thanks for the quick reply.

Josh 😀


Reply
Share: