Terry,
Try un-checking the "ACT" box at the start of that row in your set up and see if the error clears or if you just get a different error. I am no Vixen expert at all, but will poke around a bit, are you using V3 or an older version?.
Do you get the same kind of message in XLights?
I I disable the action for universes 13-15 it is fine. I don't get any errors in xlights.
Terry, should 192.168.1.207 be universes 2-13 and 192.168.1.208 universes 14-25. I just checked the numbers and I see different starting channels for the universes, see below. Again, I am no Vixen expert.
2 511 510 Unicast 192.168.1.207
3 1021 510 Unicast 192.168.1.207
4 1531 510 Unicast 192.168.1.207
5 2041 510 Unicast 192.168.1.207
6 2551 510 Unicast 192.168.1.207
7 3061 510 Unicast 192.168.1.207
8 3571 510 Unicast 192.168.1.207
9 4081 510 Unicast 192.168.1.207
10 4591 510 Unicast 192.168.1.207
11 5101 510 Unicast 192.168.1.207
12 5611 510 Unicast 192.168.1.207
13 6121 510 Unicast 192.168.1.207
14 6631 510 Unicast 192.168.1.208
15 7141 510 Unicast 192.168.1.208
16 7651 510 Unicast 192.168.1.208
17 8161 510 Unicast 192.168.1.208
18 8671 510 Unicast 192.168.1.208
19 9181 510 Unicast 192.168.1.208
20 9691 510 Unicast 192.168.1.208
21 10201 510 Unicast 192.168.1.208
22 10711 510 Unicast 192.168.1.208
23 11221 510 Unicast 192.168.1.208
24 11731 510 Unicast 192.168.1.208
25 12241 510 Unicast 192.168.1.208
Bill not sure. Renard is on a com port so I just started the universes at one as explained in the video for E1.31. I could be all wet so am hoping that some one who uses vixen and E1.31 will chime in. If I don't get it figured out I will just add more models to my xlights so I can see all the elements on the screen as I sequence. That should not be that hard. I only have the mega tree and arches at this time.
