Find and Replace do...
 
Notifications
Clear all

Find and Replace doesn't work on some values

2 Posts
2 Users
0 Reactions
2,911 Views
Posts: 39
Topic starter
(@andyb)
Trusted Member
Joined: 19 years ago
[#4630]

In another post:
( http://www.doityourselfchristmas.com/forums/showthread.php?t=571 )

It was mentioned that Find and Replace doesn't always work on some values. I believe that this occurs because of how ramps and fades are calculated. For example, I had what should have been a 50% level that I wanted to find and change to 100%. It wouldn't locate these values that were calculated. It occurred to me that the value was most likely 49.999, so I entered that into the find box. It worked. So, it looks like ramps and fades are not rounding to integer values, but instead using floating point numbers. The information display when you hover over a time interval must be converting to an integer for display. I think that all values should be rounded to the nearest integer.

I saw another post about expanding the find and replace to include a range of values to find. That would be helpful.

Andy


1 Reply
prof
Posts: 266
 prof
(@prof)
Reputable Member
Joined: 19 years ago

I have encountered similar issues with Find and Replace. Using actual values (0-255) rather than percentage has worked each time for me so far.

Craig.


Reply
Share: