SharkBite vs Apollo
 
Notifications
Clear all

SharkBite vs Apollo

34 Posts
12 Users
0 Reactions
15.8 K Views
Posts: 999
(@ppohlman)
Noble Member
Joined: 19 years ago
Stormyblade wrote:Just curious...if you are buying 10 foot sticks, how are you planning on curving/bending them?

Even the straight sticks of 1" PEX curve really easily without much effort. No need for heat guns or hot water. I used the 10' sticks of 1" Apollo from HD and simply ran a small piece of cording through the middle and tied the ends together at the desired shape (roughly 6' from the ends). For mounting, I 3D printed a couple of bases that slide over the end of the pipe and run a piece of rebar through the hole into the ground. This was more than enough to hold them up straight with out any problems.

munu wrote:I can see that the Apollo is not going to work. It is completely white/opaque whereas the ones from McMaster are semi transparent.

I thought the exact same thing when I first started looking at the Apollo pipe. Don't be too quick to judge. Once you get the lights inside, they really light up the pipe well. I was pleasantly surprised at the outcome. Especially at night, the colors come through really well.

Full Arch 1in PEX
Arch Base Detail

Reply
Posts: 602
Guest
(@bwinter)
Member
Joined: 10 years ago

1" PEX on the arches (0:33-:0:44) and 1/2" PEX on the icicles (1:07-1:15)


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

I'm actually worrying about PEX pipe bending a little too easily. If they come in coils, and you can form 10' arches with even the 1" without too much trouble, then that'll likely mean they are wobbly at around 35 feet (which is where I need it). I need a good solution that does require a heat gun.


Reply
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago
ppohlman wrote:Even the straight sticks of 1" PEX curve really easily without much effort. No need for heat guns or hot water. I used the 10' sticks of 1" Apollo from HD and simply ran a small piece of cording through the middle and tied the ends together at the desired shape (roughly 6' from the ends).

How long did you leave them with the cord holding them together? And afterwards was the curve permanent or did they straighten back out? I just bought 5' sticks from HD but think that makes the arches a little too small for my liking, end up only being about 2' at it's peak which seems on the small side. Albeit I've never actually measured arches in peoples displays before hah.

Assuming since you used a 10' stick yours would be about 4' tall but can you measure if you don't mind? I might be looking for something in between so like 36" tall but again no clue what the norm is.

Thanks,
-Russ


Reply
Posts: 427
 munu
Topic starter
(@munu)
Honorable Member
Joined: 6 years ago
ppohlman wrote:
I thought the exact same thing when I first started looking at the Apollo pipe. Don't be too quick to judge. Once you get the lights inside, they really light up the pipe well. I was pleasantly surprised at the outcome. Especially at night, the colors come through really well.

Do you know if the SharkBite is similar in transparency (or lack thereof) as the Apollo?


Reply
Page 4 / 7
Share: