I've found that the pex bends into a nice curve without much coaxing. As for holding them in the shape, I put 1" PVC tees on the ends, run a screw through the tee and the pex, drill a couple holes through the "arms" of the tees, and drive landscape nails through the holes at an angle. Then I just bend the pex into whatever arch shape I want and nail the other end to the ground. They seem to hold up well, although they haven't been subjected to severe winds or snow loads.
For the OP, check other Home Depot stores. The one closest to my house doesn't have the 10-foot pex, but the one near my office does. Same with Lowes.
I just got a couple of the McMaster pipes. I can see that the Apollo is not going to work. It is completely white/opaque whereas the ones from McMaster are semi transparent. I will wait for the other one from McMaster to come in. It seems I have to forget about the SharkBite because none of the HDs has 1"+ versions and the 3/4" are at least 300', no matter which HD I look at. No luck with Lowes, either. They also have 100' minimum and the 1.5" one is running $380 ($3.8/foot for 100').
@Kensington, do you have a picture of your setup? I am thinking of using Ts and then put some bricks on them. Maybe have a PVC pipe between both ends. I have bark in the yard so I can hide the bricks and pipe under the bark.
Yes, the PEX appears opaque. But put an LED in it...
look led in pex
Sent from my SM-N975U using Tapatalk
thats 1/2 inch pex
Sent from my SM-N975U using Tapatalk
