RGB Pixel question
 
Notifications
Clear all

RGB Pixel question

7 Posts
4 Users
0 Reactions
2,825 Views
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago
[#34208]

I ran my pixels last year using the PX1 through an E1.31 bridge from DIYledexpress last year and wanted to know if I actually needed to use the bridge to run my pixels? Can I connect the PX1 directly to a switch that is connected to my pc to run the pixels? I think I just got lucky last year when they ran, because I am still trying to learn all I can about running pixels and how they communicate and connect. Next year I want to run more pixels and outline my house with them, so i have much more learning to do. Last year was my first year putting on a show and i decided to jump right into using 500 pixels on my roof.
I am mainly just looking to learn of all the different ways they can be connected to the show computer.


6 Replies
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

The PX1 can't connect directly to the computer unless the computer has a serial port. If the PC doesn't have a serial port, you could use a USB-RS485 converter.


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago

Thanks for the info.


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

It also cannot connect directly to the network(via the switch you mentioned) It needs something to convert the E1.31 to serial which is what the bridge does. But like Phil said, if you get a USB-RS485 dongle then you can connect directly to that and skip the ethernet. The bridge can support more Renard lines than a dongle though so if you are planning expansion next year and it worked fine last year, why change it?


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Since you already have the E1.31 bridge from diyledexpress.com you could also use their pixel extender connected directly to it to power more pixels without another controller.


Reply
ksmith247
Posts: 418
Topic starter
(@ksmith247)
Honorable Member
Joined: 14 years ago

I was going to continue to use the bridge to run the show, i was thinking about using something to work on pixels while the bridge is in use with my show.

I had not seen the pixel extender before. It looks interesting.


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

Depending on what you mean by "work on" a PX1 with a USB-RS485 adapter or an Arduino could be just what you want.


Reply
Share: