NOOB T-1000 Control...
 
Notifications
Clear all

NOOB T-1000 Controller /

3 Posts
3 Users
0 Reactions
1,800 Views
Posts: 1
Topic starter
(@chadkarol)
New Member
Joined: 6 years ago
[#53562]

Good morning all,
I'm new here, and to custom Christmas lighting, although I have experience with Raspberry Pi, 3d printers, and electronics in general. I decided a couple weeks ago to begin prepping for next Christmas already, but to start off slowly just to get the basics down. I purchased a small 50 light string of RGB Pixels, a PCU, and a cheapy T-1000 controller. I figured out how to wire it all and to use LedEdit2014 to create the light show, but that software, to put it nicely, sucks. I'd really love to use different software that is more flexible, but obviously works with the T1000 controller and the ability to create .led files. I did download xLights and it seems pretty great, but I cannot figure out how to create an .led file that'll work with the T1000 controller. Any advice, thoughts, or direction would be very much appreciated. Thank you!


2 Replies
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

You should probably post your question on the XLights forum. Could get better assistance on there.

Sent from my iPhone using Tapatalk


Reply
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

There is no support for the t1000 controllers other than lededit. I tried to reverse engineer the file formats and got the header mostly worked out but the data is encrypted and I ran out of interest in it.

The controller is essentially junk.


Reply
Share: