help newbie cannot ...
 
Notifications
Clear all

help newbie cannot get controller to work

8 Posts
6 Users
0 Reactions
3,427 Views
Posts: 15
Topic starter
(@blair)
Active Member
Joined: 6 years ago
[#53970]

i cannot get the screen to power up to get my ip address as a newbie I find this really hard to figure it out I power up the board and the screen stay black i did get the beagle bone black after and put fpp on it but still nothing on the screen I have a kulp 32 board with a beagle bone black. any suggestion would be grateful


7 Replies
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

"Advanced IP Scanner" Free program is your friend.


Reply
Kev7274
Posts: 2037
(@kev7274)
Famed Member
Joined: 13 years ago

I can't see how the display is connected,is it by header pins? I don't have mine yet.
I would check to make sure things are properly seated.I would be trying to figure out why my display wasn't working,but thats just me. 😆


Reply
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

Well if the Kulp's are setup similar to the PB16, you have to access FPP and enable the display before it will turn on (not enabled by default).
Is the Kulp plugged into your home network? If it is, then as Martin suggested I would download ANGRY IP SCANNER and scan your subnet to see what is responding to pings (set start and end address of your DHCP scope).
With any luck it will respond with a netbios name of FPP or Kulp.


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

All of my Kulp controller OLEDs show up on boot, provided that I'm booting from a good image of FPP.

First, you need to verify that you actually "burned" the FPP image file to SD card rather than just copying it. If you didn't use a disk imaging file like balaenaEtcher, or Win32DiskImager, or ApplePi Baker to put the FPP image on the SD card, you don't have an operating system on the SD card to boot.

Second (or maybe first), BBBs come with the Debian distro of Linux preloaded into the 4GB on-board eMMC and by default boot from eMMC. To boot from the SD card, you have to hold down the S2 button when applying power to the BBB, and then release S2 when all the BBB lights start flashing. Otherwise, the BBB will boot from the eMMC, which doesn't have support for the OLED screen on boot. You only have to hold down S2 the first time you want to boot from the SD card.

Third, assuming you have followed the above two steps, then try to access the controller via "tethering." Run a USB cable between the BBB USB port and a computer, boot up from the SD card, wait a minute or two, then type "192.168.7.2" into your browser (or 192.168.6.2 on an MacOS device). That should get you access to the controller and you can manually modify the network information once you have booted.

For future reference, support for the Kulp controllers is handled at the BBB controller sub forum on the Falcon site: https://falconchristmas.com/forum/index.php/board,51.0.html

Dan Kulp will chime in there if someone else doesn't get you sorted out before he responds.


Reply
Page 1 / 2
Share: