Command center Idea...
 
Notifications
Clear all

Command center Ideas

15 Posts
11 Users
0 Reactions
4,774 Views
Posts: 32
Topic starter
(@toemoss)
Eminent Member
Joined: 8 years ago
[#50130]

Hello everyone,

I am working up my plans for next years system. Currently I am using a Mr Christmas 6 channel all in one and am going for the big upgrade. I am leaning to 1 or 2 16 channel renard boards in dmarc boxes and an old PC running the show. I started thinking though that I can have the show centralized in a box painted up to look like a Christmas present. This would need to be outdoors and weatherproof. I would place the PC, FM transmitter, and both renard boards in it. Does anyone have pictures of their command centers for inspiration?


14 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Hello, and welcome to the crazyness. I would suggest that you keep your PC indoors, or even in the garage. Your controllers can be hundreds of feet from your PC via Cat5 if you wish. You will need access to your PC to start and stop the show shedule software you plan to use, or even to make adustments to your sequences.


Reply
Posts: 32
Topic starter
(@toemoss)
Eminent Member
Joined: 8 years ago

I have not come up with a good way to get the cat5 out of my garage except for out the main door which will get beat on by the door going up an down.


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

Cat5 or 6 should be able to run under the garage door without getting damaged. This is assuming it is a standard garage door with a rubber seal at the bottom.

Some have run cables through a dryer vent that is used just as an exit point for cabling. Other have installed a weatherproof rj45 jack on the outside of the garage. Both of these would require cutting a hole in your exterior wall.

I do not know of anyone who has the PC located outside. A raspberry Pi or the like, sure but not a PC. This does not mean it can not be done. If that is the solution you need for your circumstances then run with it. Maybe a headless PC that can be remoted into would be a good solution for you.


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

The door opening and closing shouldn't hurt the cable, you can put a short piece of wire loom over it and that should be sufficient. The Renard in CG cases are perfectly fine in the weather. I have some pictures of some really cool stands that I use for mine that keeps them off the ground and accessible if needed. Putting the controllers outside near the display items allows you to use much shorter cords and makes storage easier as well. If you are still wanting to put the PC outside though, what I use is a garden tool shed like the picture below with a shelved rack.

shed

Reply
Page 1 / 3
Share: