Dirk Cheap SSR Help
 
Notifications
Clear all

Dirk Cheap SSR Help

10 Posts
8 Users
0 Reactions
7,402 Views
Posts: 232
(@jdawgbailz)
Reputable Member
Joined: 13 years ago
steve honour wrote:Hi Guys wet and cold here in the uk, so my question is can you build these for 240 v for use in the uk and what would I need to change ? to make it work.
I have only just started in this hobby / obsession.
the reason I like the sound of this bored is the fact that if you say its only a few $ then double that for the uk and I can just about afford them. I'm using vixen 2:1x and an arduino mega, have just managed to get an 8 channel relay board to work so im looking for other alternatives, would I be right or wrong thinking that if I used these board I could forget the arduino and just come straight out of vixen to the board and from the board to my lights.
thanks

I'm also new here and with the hobby but that is not possible. You will need some type of micro controller between the board and the feed coming from Vixen. You can use a Renard, Arduino, and there are also some other ones out there. I'm not sure if you can use them for 240v (I don't think you can, but don't quote me on that)


Reply
Posts: 57
(@aclarksr)
Trusted Member
Joined: 13 years ago

Steve,

Just looking at the PCB schematic and the specs on the optocouplers used you should be able to adapt these to a 240vac single phase circuit. I would assume that the current limitation would be reduced by the higher voltage, Ohm's law and all. I am just starting out with this hobby so you may want to wait for a Senior Member to respond.

Drew from Deer Park, TX


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

If the chip will handle 220V AC, then the next consideration is trace spacing. THAT is where some of the SSRs and Controllers fall apart in the transition from 120V to 220V. For example, that is the reason, if think, that the SS series of Renard Controllers aren't rated for use with 220V. When I did the SSRneon, that was one area where peer review was very helpful.


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

Since these are Mr. Nerkle's design, you will likely get quicker response from the man himself if you ask on his site over at diychristmas.org... just a thought.


Reply
Posts: 20
(@steve-honour)
Eminent Member
Joined: 13 years ago

Thanks for the input guys.
im thinking a little more research needs to be done


Reply
Page 2 / 2
Share: