Notifications
Clear all

Dancing Skeleton

8 Posts
6 Users
0 Reactions
16.7 K Views
Posts: 2630
Topic starter
(@dynamoben)
Famed Member
Joined: 19 years ago
[#2638]

The last Halloween I decided I needed yet another kid friendly prop to add to my singing pumpkins show. After reading about crank ghosts I built this glow in the dark (via black light) dancing skeleton. His motor and blacklight were controlled via DMX. The motor controller was variable speed so his dancing was in sync with the music. I designed the motor controller from scratch and used an old PC power supply for 12V to power the motor.

The photos are pretty self explanatory. What you can't see is the automotive windshield wiper motor (above) and the new fasteners in the skeletons joints. When I purchased the skeleton he had rivets which didn't allow for much movement. I removed the rivets and used threaded rivets (they screw together) from the hardware store.

I used this site as my guide: http://www.scary-terry.com/dancskele/dancskele.htm

Enjoy.

halloween 2007 027
halloween 2007 028
halloween 2007 029

7 Replies
kmc123
Posts: 824
(@kmc123)
Prominent Member
Joined: 19 years ago

Very Cool!!!


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 19 years ago

Very Nice Ben. Any chance of a video?


Reply
Posts: 2630
Topic starter
(@dynamoben)
Famed Member
Joined: 19 years ago

You can kind of see him on the porch (sorry for the low quality, better videos on the way).


Reply
teberle
Posts: 641
(@teberle)
Honorable Member
Joined: 19 years ago

Ben,

That is the same rig I used to make my crank ghost with. What motor did you use AC or DC. The AC motors were expensive!!!

Tony


Reply
Page 1 / 2
Share: